Wash Day Without Electricity
(Or Even Running Water)
You need to wash your clothes but there is no washer and dryer, so what do you do?
There are two #3 galvanized wash tubs at the back of the house and a 30 gallon cast iron
wash pot at the side of the house. Now you need some water but there is no faucet to get
it from as there is no running water on the place. The nearest source of water is a
windmill about a hundred yards from the house.
You get your 2 gallon water bucket, or more then likely one in each hand,and head for
the windmill. When you get the buckets full of water, you head back to the house and
pour the water into the wash pot. Then you make another trip and another until you get
the pot about half full. Then you throw some logs around the pot and set fire to them to
heat the water.
While you waited for the water to get hot, you set the galvanized tubs on a bench near the
washpot and go back to the windmill and get more water for them. This is the cold water
rinse. After you finish this you bring out the clothes and seperate them. By now the water
in the pot should be hot.
You take the white clothes first, because you want to boil them in clean water, and put
them in the pot. Detergent? No, you take a cake of the lye soap that you made last fall
and shave off some of it into the pot. Now you take the ‘punching stick’ which is usually
kept leaning against the side of the house and punch the clothes down in the water and
give them a little stirring motion. This will help to dissolve the shavings of the lye soap
and agitate the clothes similar to what the washing machines do today.
After the water goes to boiling again you punch the clothes down and stir them a couple
more times. After that you take the stirring stick and lift the clothes out of the pot and
put them in the first tub of rinse water. While they soak in the rinse water, you get the
slightly soiled colored clothes and put in the wash pot, being sure to save the heavily
soiled work clothes for last. You may also need to shave off a little more of the lye soap
into the pot.
Now you go back to the white clothes you have in the rinse water and punch them down
and stir them around some so rinse the soap out and then move them into the second
rinse water for a final rinse.
Whenever you got to the work clothes you would find that some of the grime would not
come out during the boiling and agitation. After you moved them to the first rinse water
you would then get out the rub board. “What’s that,” you ask?” Go to your local
museum and ask them if they can show you a rub board, or they may call it a scrub board.
You place the rub board in the tub with the legs against the bottom side away from you.
You then pull up the soiled clothes and place on the board with the soiled side up and
rub it down good with the cake of lye soap, then turn it over and rub it back and forth
vigoursely against the ridges on the rub board, rinse and see if it’s clean. You may have
to do this two or three times to get it clean.
You notice that we have used the same water from the time we started washing. It takes
too much time to dump the water out of the wash pot, refill it and rebuild the fire to
reheat it, so that is why we start with the white clothes first and work on down to the
more soiled work clothes. Sometimes the rinse water would have to be changed.
Now you have the clothes washed but no dryer. What do you do?
Well, there is a wire stretched between two trees in the back yard you can hang the
colored clothes on that you do not want the sun to fade. The rest can be hung on the yard
fence. The barbs on the barbed wire will keep the clothes from blowing off and save
you from having to use clothes pins.
This is nice for the summertime, but what about in the winter? That’s when you set the
tubs up in the kitchen, carry the water in and put it in pots on the wood stove to heat,
then pour it into the tubs and wash everything on the rub board. You would want to pick
a day when it wasn’t freezing outside, or your clothes would freeze before they dried, or
wash a few necessary clothes and hang in the house to dry.
Now you know why the old folks always set aside a full day to do the washing.
After you finish the washing you have some clothes that need ironing. How do you
accomplish that? How about with a “smoothing iron?” These were made of solid cast
iron and came in different weights ranging from about 2 to 5 pounds. You would select
the weight iron to use according to the type material you wanted to press, a denim would
require a heavy iron and a gingham would need a light iron.
To use the irons you would set them on top of the wood stove until they got hot. You
could only iron a little with each one before it cooled off, then you would have to reheat
it. That is why most people had two of each weight, so that one could be heating while
they were using the other one. Most of them had a handle that was cast with the iron
making it one piece and they would get nearly as hot as the iron and you needed some
type of pad to hold the iron with. However, some of the more expensive ones had coils
around the handle and they didn’t get as hot.
This could be a very hot job in the summer, especially with no air conditioning. You
would usually set the ironing board up near the cook stove in the kitchen and do the
ironing while you cooked the noon meal. This way you didn’t need to have a fire in the
stove any longer than absolutely necessary, and by doing it in the morning it wasn’t quite
Between carrying water, scrubbing clothes on a rub board, handling those cast iron
smoothing irons and the other work they did, the women of that time didn’t need to go to
a gym to get exercise, they got plenty in their daily activity.
old iron wash pot, wash tubs and rub board.
All that remains of the old homeplace today are a few
rocks scattered around where the house once sat and
the double row of rocks in this photo marking the
walkway from the house to the yard gate. You can
see the windmill in the distance that we carried
|Texas Tales, Jokes & Anticdotes|
|Johns Poetry Corner|
|Over The Backfence|